Low water pressure in a Tampa home is usually caused by mineral buildup in faucets and shower heads, a partly closed shut-off valve, a failing pressure-reducing valve, a hidden leak, or old galvanized pipes that have corroded inside. Normal household water pressure is 40 to 80 psi. If yours tests below 40 psi, or only one fixture is weak, the steps below will help you find the cause.
We’ve been diagnosing water pressure problems in Tampa Bay homes since 1976. Here’s how to test your pressure, narrow down the cause in a few minutes, and know how each one is fixed.
Need help now? Our licensed technicians serve all of Tampa Bay, 24/7.
Step 1: Figure out where the pressure is low
Where the problem shows up tells you a lot about the cause:
| What you notice | Most likely cause |
|---|---|
| One faucet or shower is weak | Clogged aerator or shower head, or a bad cartridge in that fixture |
| Only the hot water is weak | Sediment in the water heater or a partly closed valve on the heater |
| The whole house is weak | Main shut-off valve, pressure-reducing valve, a leak, or the city supply |
| Pressure dropped suddenly | A leak, a main break, or city work in your area |
| Pressure got worse slowly over years | Mineral buildup or corroded galvanized pipes |
Step 2: Test your water pressure
An inexpensive screw-on pressure gauge from any hardware store does the job. Screw it onto the outdoor hose bib closest to where your water line enters the house, make sure no water is running inside, and open the spigot all the way.
- Below 40 psi: low. You’ll notice weak showers and slow-filling toilets.
- 40 to 80 psi: normal. 50 to 70 psi is ideal for most homes.
- Above 80 psi: too high. Florida’s plumbing code requires a pressure-reducing valve when the supply is above 80 psi, because high pressure wears out fixtures, water heaters and supply lines.
8 common causes of low water pressure
1. Mineral buildup in aerators and shower heads
Tampa’s water is hard, about 12 grains per gallon according to the city’s 2025 water quality report. Calcium and magnesium build up in the small screens and holes of faucet aerators and shower heads. Unscrew the aerator, rinse it, and soak it in white vinegar overnight. If the pressure comes back, that was the problem.
2. A partly closed main shut-off or meter valve
After a repair or a plumber’s visit, the main valve is sometimes left partly closed. Find your main shut-off, usually where the water line enters the house or in the garage, and make sure it’s fully open.
3. A failing pressure-reducing valve (PRV)
Many Tampa Bay homes have a bell-shaped PRV on the main line. They usually last 10 to 15 years. When one fails, pressure can drop throughout the house, or swing up and down.
4. A hidden leak
A leaking pipe under the slab, in a wall or in the yard sends water somewhere other than your faucets. Turn off every fixture and watch your water meter. If the dial still moves, you have a leak. Our guide to why your water bill is so high covers more leak warning signs.
5. Corroded galvanized pipes
Homes built before the mid-1970s often have galvanized steel water lines. Over decades they rust from the inside, and the opening narrows until little water gets through. Low pressure combined with rusty or brown water is a strong sign. The long-term fix is whole-home repiping.


6. Sediment in the water heater
If only your hot water is weak, sediment may be clogging the tank’s outlet, or the valve on the water heater may be partly closed. Flushing the tank once a year helps. Water heaters over 10 to 12 years old with heavy sediment are often due for replacement.
7. A clogged water filter or softener
Whole-house filters with old cartridges, and water softeners with a stuck bypass valve or failing resin, can restrict flow to the whole house. Try putting the system in bypass. If pressure jumps, the system needs service.
8. A problem on the city side
Ask a neighbor if their pressure is low too. If it is, there may be a main break, hydrant flushing or construction nearby. Check with your water utility before calling a plumber.
Common fixes for low water pressure
- Clean or replace aerators and shower heads
- Replace a faucet or shower cartridge
- Replace a pressure-reducing valve
- Replace a main shut-off valve
- Leak detection and repair
- Replace the water service line from the meter
- Whole-home repipe
Frequently asked questions
What is normal water pressure for a house?
Normal residential water pressure is 40 to 80 psi, and 50 to 70 psi is ideal. Below 40 psi feels weak. Above 80 psi is too high and needs a pressure-reducing valve.
Why is my water pressure suddenly low in my whole house?
A sudden whole-house drop usually means a leak, a partly closed main valve, a failed pressure-reducing valve, or a problem in the city’s main. Check with a neighbor first. If their pressure is fine, check your meter for a leak.
Why is only my shower pressure low?
Mineral buildup in the shower head is the most common cause in Tampa because of our hard water. Soak the head in vinegar overnight. If that doesn’t help, the shower valve cartridge may be worn or clogged.
Can a water softener cause low water pressure?
Yes, if it’s undersized, the resin is clogged or a valve is stuck. Put the softener in bypass mode. If your pressure returns to normal, the softener needs service.
Is low water pressure a sign of a leak?
It can be. If your pressure dropped and your water bill went up, turn off all fixtures and watch the meter. A moving dial means water is leaking somewhere.
How long do pressure-reducing valves last?
Most PRVs last 10 to 15 years. Hard water can shorten that. Signs of failure include pressure that swings up and down, banging pipes, or a sudden drop throughout the house.
Why Tampa homeowners choose Alvarez for water pressure problems
- 50 years in Tampa Bay. We’re a family-owned company that has served Tampa Bay homes since 1976.
- Thousands of 5-star reviews. We’re rated 4.8 stars from more than 2,700 Google reviews and are BBB A+ accredited.
- No subcontractors. Every job is done by our own trained, licensed technicians, so the people who quote your job are accountable for the work.
- We guarantee our work. We stand behind every job we do. If something isn’t right, we come back and make it right.
Get your water pressure fixed
We’ll test your pressure, find the cause, and give you a written estimate before we start. Call (813) 655-7520 or request service online. Learn more about our residential plumbing services.
Book online in under a minute, or call and talk to a real person.